SG-TRONIC MOTORSPORT • WORK GALLERY
AudiAutomatic Transmission TCM DQ200-G2 Programming
This Audi case study shows bench programming and controlled electronic handling of an automatic transmission control module (TCM) identified as DQ200-G2. The workflow involved supported communication, module-level data handling and diagnostic-led verification using professional workshop equipment.
Gearbox and transmission control module procedures vary by vehicle platform, software version, fault history and the condition of the mechatronic or TCM assembly. Each unit should be assessed individually before any programming, cloning or configuration work is carried out.
Audi TCM programmingDQ200-G2Automatic transmissionBench diagnostics
Job summary
Automatic transmission TCM programming
DQ200-G2 gearbox control unit
SG-Tronic Motorsport • Stourbridge workshop
Image gallery
Audi transmission-control-module bench programming setup.
Workshop media showing an Audi automatic transmission TCM DQ200-G2 connected on the bench with the programming interface, diagnostic tablet and supporting electronic equipment used during the job.
TCM bench programming setup
The transmission control module is connected on the bench to allow stable communication, supported data handling and workshop-side diagnostic checks before the unit goes back into service.
Workshop notes
Diagnostic-led Audi gearbox control module support.
This Audi automatic transmission TCM DQ200-G2 programming case study helps demonstrate the type of gearbox electronics and bench-programming work completed at SG-Tronic Motorsport in Stourbridge near Birmingham. Services for supported Audi, VW Group and DSG-related control units may include identification, cloning, data transfer, replacement-module setup and other programming tasks depending on the hardware and software version.
Audi gearbox enquiry
Send the gearbox or module details before booking.
For Audi automatic transmission, DSG, mechatronic or TCM programming enquiries, send the vehicle registration, VIN, module part number, gearbox code and a short description of the fault or replacement history.
For a similar replacement or non-communicating controller, see DSG, TCU and gearbox-module programming. Include the gearbox code and both controller labels. For an approved postal enquiry, follow the UK module postage guide.
