SG-TRONIC MOTORSPORT • WORK GALLERY
Peugeot PartnerBSI & Airbag Module Replaced & Programming
This gallery shows a Peugeot Partner workshop job involving BSI access, wiring inspection, airbag module replacement, module programming and inspection of corrosion-damaged electronic hardware.
Customer-identifying details have been hidden for privacy. The gallery is intended to show real working methods and the type of diagnostic-led module work completed at SG-Tronic Motorsport.
BSI replacementAirbag module replacementProgramming & configurationWorkshop diagnostics
Job summary
BSI & airbag module replaced and programmed
Workshop diagnostics, programming and module work
SG-Tronic Motorsport • Stourbridge workshop
Image gallery
Vehicle access, module removal and corrosion inspection.
The photo set below follows the job through the wiring and control-module access stages, the airbag module location, and the visible condition of the replaced BSI hardware.
BSI identification & access
Initial access to the vehicle-side BSI area for identification, connector positioning and programming preparation.
Dashboard wiring access
Interior trim removed to reach the control units and related vehicle wiring required for the programming and replacement process.
Airbag module location
Airbag ECU area exposed for module replacement and further configuration work.
Opened BSI hardware
The removed BSI unit opened for inspection, showing corrosion and contamination affecting the board area.
Corrosion close-up
Detailed close-up of the affected section on the BSI board, illustrating the type of damage that can lead to module failure or communication problems.
Vehicle ready outside the workshop
Exterior shot of the Peugeot Partner at SG-Tronic Motorsport following the job, with registration and face blurred for privacy.
Privacy & notes
Real workshop media, with privacy protection applied.
Registration details and identifiable face imagery have been obscured before publication. Gallery content is published only to show the type of work completed by SG-Tronic Motorsport; module compatibility, programming procedure and final repair path always depend on the exact vehicle, hardware, software and fault condition.
Need similar help?
Send the vehicle details before booking.
For BSI, BCM, airbag, immobiliser, ECU or diagnostic enquiries, send the registration, VIN, part number, fault codes and clear module-label photos for a faster assessment.
Read about Peugeot and Citroën BSI cloning and programming or airbag ECU programming and crash data assessment. A replacement module must be checked against the vehicle and fault before a booking is approved.
